#Latest version of pcalc usum how to
#Latest version of pcalc usum install

You can advance frames by pressing Start to unpause the game. These frames are considered Safe Frames and can be used to accurately predict the frames you can land on.You can find this in the PCalc Game Info window ( Start + Up) and then press Start + Select to pause the game.Ĭlick 'Calculate', and then advance to any of the frames that are listed that have a '-' in the Mark column. Input the frame you are currently on in the frame range. In the game, advance to the final screen for the Pokemon you are RNGing for. Let the game run for approximately 30 seconds to a minute to calibrate correctly.If you already have it up, close it by pressing Start + Up, and then bring it back up again to reset the NPC counter.After getting to the final screen for your Pokemon press Start + Up to bring up the window with the NPC counter.3DSRNGTool should automatically fill in this number, but it can be confirmed with PCalc. Initial Seed can be found by pressing Start + Up ingame.Įnter the number of NPCs for the area.In 3DSRNGTool, make sure to input your initial seed, game version, and your TSV if you haven't already. 3DSRNGTool can accurately predict all of this if the timeline is created properly and allow you to land on your target frame without skipping over it due to NPCs. There is also Rotom and your character blinks that affect the frames advanced. In general, each NPC advances the frames by one, so an area with four NPCs will generally advance five frames each time. This is why the frames will not always advance by a constant number. Note: In the Gen 7 games each NPC has an affect on the RNG frames.

#Latest version of pcalc usum how to

Refer to the guide you are following for more information on how to RNG in Gen 7 with 0 NPCs. If you are in an area with 0 NPCs the RNG procedures are different, and no timeline is needed. A timeline is able to accurately predict what frames you can actually land on. If you are in an area with an NPC count of one or more you must always create a timeline before searching for a target frame. If you have the Shiny Charm check the Shiny Charm box. The initial seed is found where it says Init Seed. You can find this by pressing Start + Up to bring up the Game View window. Your TSV is listed by where it says YOUR TSV. With PCalc, you can find your TSV by pressing Start + Up to bring up the Game View window.Step 1: Set Up 3DSRNGTool In the upper right of 3DSRNGTool:

#Latest version of pcalc usum install

A 3DS with PCalc ( PCalc Install Guide)īefore continuing with the guide it is recommended to be in the place you wish to RNG.

Timeline Guide The most needed skill to do Gen 7 RNG with custom firmware Tools